831 North Mountain Road · Newington, CT 06111
Tel: 860-953-7632 · Fax: 860-953-9234

WATERPROOF IP67
The sensor can be hosed down because of it's IP67 construction

THE SOLUTION TO YOUR REQUIREMENTS!

• Miniaturization by Using Single Chip Optical IC!
  The beam receiving photodiode and the A/D conversion circuit have been fabricated on a single chip optical IC (full custom). Hence in spite of its miniature size, it has a performance and reliability which is equal to or better than the conventional product.

• Long Sensing Range Realized
  The UZB5/6 series achieves long distance sensing [thru-beam type: 2m 6.562ft, retroreflective type: 200mm 7.874inch (when using the attached reflector), diffuse reflective type: 160mm 6.300inch], despite its miniature size. Hence it is usable even on a wide conveyor.
• Bright Two-color Indicator
  Bright two-color indicator has been incorporated in all types.
• Slit Mask is Available
  ø0.5mm ø.020inch round slit mask and 0.5 x 3mm .020inch x .118inch rectangular slit mask are available for both side and front sensing types.

• Clear Beam Spot by Using a Red LED Dot Light Source
  The emission area of a dot light source is smaller then that of a conventional LED flat light source, and it is possible to design a high power, narrow beam.
  Since a red LED dot light source is used, the red beam spot is clear even at a far place, so that alignment and confirmation of sensing position is easy. Further, since the thru-beam type, too, incorporates a visible beam, it can also reliably detect small parts, such as, chip components, lead frames, etc.

• Incorporates a Sensitivity Adjuster Even in this Size.
  The sensor incorporates a sensitivity adjuster in spite of its miniature size. It is convenient when you need fine adjustment. Further, the receiver of the thru-beam, side sensing type sensor incorporates an operation mode switch which can change the output operation.
  

• Mounting Section Reinforced
  It can be tightened with M3 screws.
  Moreover, metal inserts have been provided in the mounting holes so that the product is not damaged even in case of excess tightening.